Handle , Ropes & Tilt Head.

As you attach the handle to the pole make sure the large cylinder of the handle is on the left side of the pole. Also make sure that when you attach the tilt plate to the pole, that the "L" shaped bracket extends to the left side as well. This way the handle cylinder is directly beneath the pulley mechanism attached to the tilt plate. The ropes should extend straight up, for simple pulley control.

Notice ropes exit and travel on either side of the tilt cylinder. They extend and line up with the pulley wheel, directly above them. The Carabiner connectors make it very easy to attach and detach the handle from the tubes.









(Also note that the lock mechanism on the cylinder is NOT on the top of the cylinder, but on the bottom.) By putting the lock mechanism on the bottom of the cylinder , the user will have 180 degrees of rotation. If it is not at the bottom , the range of motion is very limited and unsmoothe.