Attaching Head to Tubes

Remove the L-shaped yoke/camera plate from the case. This is the only HI-POD piece that will require a tool. Remove this piece from the box and notice its L-shaped design. Now look at the top of the HI-POD. There is a slot cut out of the top spud. This slot is made to accommodate the L-shape of the camera/yoke/plate. Slide the L-shaped yoke/plate into this slot. Notice the opening.

This will accept that large 6mm allen screw. Make sure the L-shape is to the left (as in the picture below). Insert the bolt(that you removed from the top of the tube spud) and tighten. You should use an allen key (metric #6 to be exact) to tighten the yoke to the tubes.

Notice there are a number of small holes drilled through the yoke. These holes can be used creatively to secure future items to the HI-POD head. If desired use a zip-tie to secure the cable to the yoke.